Sterling silver conductive paint is anti-electromagnetic interference spray made of silver particles by Shenzhen Xinshengfeng Technology Co., Ltd., single component, labor saving, time saving, convenient, good adhesion, smooth, strong cohesion, no loose particles, available Spraying materials on the inner wall of a mobile phone, a calculator, a precision instrument, etc., which are made of metal or composite materials. The paint performance is stable after drying and curing, and is suitable for single-piece batch spraying factory production. At the same time, it only needs to spray a thin layer to have good electrical conductivity.

Product nature:

Conductive material: silver particles

Binder: thermoplastic (when the original barrel comes)

Solid content (%): 40±2

Theoretical coverage area: 4m2/kg

Best shelf life: the original barrel can be kept for 6 months

Volatile components: about 612.12g / kg (when spraying)

Recommended film thickness: should be 10 to 15μm (dry film)

Conductive properties: 0.015 Ω / cm 2 / 15 μm

Electromagnetic noise attenuation: 70 db

Thinner: Alcohol

Stirring and dilution:

It is easy to mix well and shake it with a shaker for 5 minutes. It is necessary to check that there is no sediment at the bottom of the barrel before it is shaken (especially when mixing with hands). Please use BL-338 thinner, the dilution ratio is 1:0.5 (volume ratio).

Spraying method:

This coating can be sprayed with conventional spraying equipment, or it can be sprayed with more advanced low-pressure and high-injection equipment, which will have better effect and save paint. It can also be sprayed with fully automatic mechanical arm.

After the spray film is dried, it should have a thickness of 15μm to have sufficient anti-interference ability. However, depending on the actual requirements of the user in terms of anti-interference, the coating film can be thinner. It is necessary to prevent dry spray when spraying, and the dry spray will cause coating. The adhesion of the film is insufficient and rough.

      The surface of the spray must be clean and dry.

Dry solid:

Dry naturally for 5 minutes after spraying, then use 71 ° C (1600 F)